Saturday, December 1, 2012

DIY fabric-covered pencil tin

If you want to give your workspace or the kids’ craft table an instant lift, here’s a quick and easy project that even the older kids will be able to do themselves. These would also make a great gift for school teachers or grandparents.
 
Supplies:
1 empty food can (400g size), washed thoroughly, labels removed
Fabric of your choice (a 15cm cut or fat quarter will be ample)
Heavy fusible interfacing
Spray adhesive
Craft glue

 
Step 1: Make sure you are using a can with no sharp edges. Measure the height of your can (not including that little round lip on the top and bottom edge) and add 2cm (you will have a measurement of about 12.5cm).

Step 2: Next, mark out and cut (or cut using a rotary cutter and rule) a rectangle of interfacing that is 26cm wide x the height you measured in step 1 (12.5cm).
 

 
Step 3: Fuse your interfacing to your fabric, and if you have a directional print remember that the long sides of the interfacing will be the top and bottom of your can.
 

Step 4: Cut around the piece of interfacing.

 
Step 5: Using a piece of cardboard if you have one, mark a pencil line 1cm from the long edge of your card. This will form your pressing template. Starting on the two long sides, turn under and press a neat 1cm hem. Topstitch each of the long sides down, about 5mm in from the edge. If you don’t have a sewing machine, this could also be done by hand.

 
Step 6: Turn under ONE short end and press a 1cm hem. Top stitch as above. There is no need to hem the other short end. You should then having something that looks like this:

 
Step 7: Apply spray adhesive to the back of your fabric and starting with the raw end, carefully roll your fabric around the can. When you get to the hemmed end, apply a small amount of craft or hot glue and press down firmly.


 
HAVE FUN!
 



 


 

 

4 comments:

  1. What tins do you use that aren't sharp??

    ReplyDelete
    Replies
    1. could also try like milo cans then you just need to make sure the 'metal' seal inside is removed fully

      Delete
  2. Miss Meg - We have one of those new-fangled can openers that don't leave any sharp edges (Zyliss is the brand of mine). Otherwise, I find ring-pull cans also work fine. Hope that helps!

    ReplyDelete
  3. Thanks for sharing this - one of my kids made some for their siblings' Christmas presents this year, very well received!

    ReplyDelete